TM 1-1520-238-23
16-32
Change 8
16.5.
PYLON RACK DISASSEMBLY/ASSEMBLY (AVIM) - continued
(4) Apply primer to new spring pin (58). Use
epoxy primer coating kit (item 78, App F)
(TM 55-1500-345-23).
(5) Apply grease sparingly to pin (59). Use
grease (item 86, App F).
(6) Insert pin (59) in bellcrank (51).
(7) Aline hole in pin (59) with hole in bellcrank
(51). Ensure slotted end (69) of pin (59) is
alined with mount hole for pin (56). If slotted
end (69) does not aline with mount hole in pin
(56), reverse pin. Install spring pin (58)
(TM 1-1500-204-23).
(8) Apply grease sparingly to pin (56). Use
grease (item 86, App F).
(9) Place sleeve bearing (57) in clevis of bell-
crank (51).
(10) Insert pin (56) through bellcrank (51) and
sleeve bearing (57).
(11) Install two washers (55).
(12) Install two new cotter pins (54).
(13) Apply grease sparingly to pin (52). Use
grease (item 86, App F).
(14) Install pin (52) in hook (53).
(15) Assemble spring (27), spring (26), and
spacer (28) on rod (25).
NOTE
Ensure temporary cotter pin is positioned
to allow removal after aft hook assembly
is installed in rack.
(16) Insert rod (25) through hole in pin (52). Com-
press springs (26) and (27) until hole in rod
(25) extends beyond pin (52).
(17) Install cotter pin (24) through hole at end of
rod (25) to retain springs (26), (27), and
spacer (28).
GO TO NEXT PAGE
51
55
58
57
55
54
56
59
7
8
TOP VIEW
VIEW ROTATED
M04-2704-56A
25
27
28
24
52
53
26
M04-2704-57A
