TM 1-1520-238-23
16-36
Change 8
16.5.
PYLON RACK DISASSEMBLY/ASSEMBLY (AVIM) - continued
f. Attach link (30) to aft hook assembly (29).
(1) Apply grease sparingly to pin (33). Use
grease (item 86, App F).
(2) Insert pin (33) through link (30) and eye bolt
(60) of aft hook assembly (29).
(3) Install washer (32) and new cotter pin (31).
(4) Insert bolt (60) in aft hook assembly (29).
NOTE
Ensure both hooks are in LOCK position.
g. While applying pressure with finger to stud
end of bolt (60), measure distance between
shoulder of bolt (60) and attach point on aft
hook assembly (29).
(1) If distance is less than 0.005 INCH, install
washer (62) and nut (61) then go to step i.
(2) If distance is greater than 0.005 INCH, go to
step h.
h. Adjust distance between back of bolt (60) and
attach point on aft hook assembly (29).
(1) Remove bolt (60) from attach point on aft
hook assembly (29).
(2) Add washers (62) as required until distance is
less than 0.005 INCH between shoulder of
bolt (60) and attach point on aft hook assem-
bly (29).
(3) Insert bolt (60) through aft hook assembly
(29).
(4) Install washer (62) and nut (61).
GO TO NEXT PAGE
32
60
31
30
33
M04-2704-66
60
29
M04-2704-72
.005
OR
LESS
60
29
62
60
30
61
M04-2704-67
62
62
