TM 1-1520-238-23
Change 8
16-53
16.9.
PYLON ACTUATOR AND TOP PLATE REMOVAL/INSTALLATION - continued
16.9.6. Installation
a. Install actuator (14) and plate (10) on pylon
(15).
(1) Position actuator (14) and plate (10) on pylon
(15).
(2) Install actuator (14) and plate (10) in pylon
(15). Ensure plate (9) is through plate (10).
(3) Aline plate (9) to plate (10). Install two screws
(11) and washers (12).
(4) Aline holes. Install six bolts (16) and washers
(17).
b. Attach connector P507 (1) to receptacle J507
(2).
c. Install actuator rod end (3) in yoke (4). Aline
holes. Torque nut (7) to 285 to 500 INCH-
POUNDS.
NOTE
If required add or remove one additional
washer to aline cotter pin hole.
(1) Install bolt (6), washer (8), and nut (7).
(2) Hold bolt (6). Torque nut (7) to 285 INCH-
POUNDS. Use torque wrench.
(3) Increase torque to aline cotter pin holes, but
do not exceed 500 INCH-POUNDS.
(4) Install new cotter pin (5).
d. Inspect (QA).
e. Install pylon (para 16.2).
f. Install pylon fairings P1, P2, and P3 (para 2.2).
END OF TASK
15
10
17
16
14
11
9
12
M04-2708-10
1
2
M04-2708-8
7
M04-2708-1 1
4
6
38
5
