TM 1-1520-238-23
Change 8
16-93
16.19.
PYLON CIRCUIT CARD AND JETTISON WIRE HARNESS REMOVAL/INSTALLATION - continued
(3) Remove and discard resistor (16) from card
(4).
(4) Install new resistor (16) on card (4).
(5) Install two nuts (19) and two washers (20) on
card (4).
(6) Solder wires (17) and (18) to resistor (16).
Use solder (item 189, App F) and soldering
iron (TM 55-1500-323-24).
NOTE
This repair is typical for electrical contact
module TB1 or TB2.
c. Repair card (4) by replacing terminal block
module (21).
(1) Identify and remove wires (22) from module
(21).
(2) Remove and discard module (21) from
mounting bracket (23). Use socket removal
tool.
(3) Install new module (21) on mounting bracket
(23).
(4) Install identified wires (22) to module (21).
d. Inspect (QA).
GO TO NEXT PAGE
20
M04-2942-9
4
18
19
16
17
19
20
M04-2942-10A
23
21
22
4
