TM 1-1520-238-MTF
4-19
Change 5
6. IAT/MAN switch– Engage and track target. If
tracker enters stop mode, press IAT/MAN switch
to select MAN. Repeat step.
NOTE
The TADS turret will begin oscillating (roll-
ing) around the target; when the boresight
menu appears, the alignment is complete.
7. IAT – OFF.
8. FOV – As required.
9. TADS – As required.
L. HARS SELF TEST.
CAUTION
The helicopter must not move during
HARS self test. Any movement will result
in an invalid self test.
NOTE
The HARS self test can be used only with
HARS units having part numbers
86-9415-5 and above.
The HARS self test should be performed
on the ground with APU power only.
1. FCC/MUX switch – ON.
2. MUX switch – PRI.
3. SYSTEM FC SYM GEN switch – FC SYM GEN.
NOTE
and .
If the DEK is in the FD/LS
position when the HARS alignment is initi-
ated, the heading tape will not appear; set
DEK switch to STBY.
