TM 1-1520-238-23
Change 3
2-177
2.58.
CPG STATION ACCESS DOOR LOWER HINGE BUTT REMOVAL/INSTALLATION
2.58.1. Description
This task covers:
Removal. Cleaning. Inspection. Installation.
2.58.2. Initial Setup
Tools:
Airframe repairman’s tool kit (item 377, App H)
Light duty laboratory apron (item 27, App H)
Chemical protective gloves (item 154, App H)
Adjustable air filtering respirator (item 262, App H)
0 - 30 inch-pound 1/4-inch drive dial indicator torque
wrench (item 445, App H)
Materials/Parts:
Cotter pin
Brush (item 34, App F)
Sealing compound (item 176, App F)
Personnel Required:
68G
Aircraft Structural Repairer
One person to assist
67R3F
Attack Helicopter Repairer/Technical
Inspector
References:
TM 1-1500-204-23
Equipment Conditions:
Ref
Condition
1.57
Helicopter safed
NOTE
This task is typical for left and/or right
CPG station lower hinge half removal/
installation.
2.58.3. Removal
a. Close and latch CPG station access door (1).
b. Remove lower hinge butt (2) from CPG station
access door (1).
(1) Remove and discard cotter pin (3) from hinge
pin (4).
(2) Remove hinge pin (4) (TM 1-1500-204-23).
(3) Remove three screws (5) and washers (6).
(4) Remove five screws (7).
(5) Remove hinge (2) from door (1).
GO TO NEXT PAGE
M04-1442-1
3
1
7
5
6
2
4
M04-1442-2A
