TM 1-1520-238-23
2-344
Change 6
2.94.
LEFT AFT SIDE TRANSMISSION ROTOR SUPPORT STRUT ASSEMBLY
REMOVAL/INSTALLATION continued
2.94.6. Installation
a. Install strut (2) on strut (24). Torque two nuts
(26) to 600 INCH-POUNDS.
(1) Install two bolts (25) in strut (2) and strut (24).
(2) Hold two bolts (25). Install two washers (27)
and nuts (26).
(3) Torque two nuts (26) to 600 INCH-POUNDS.
Use torque wrench and adapter.
(4) Check for maximum gap of 0.050 INCH under
washer (27) at bolt (25) head and nut (26)
side. Replace bolt (25) if gap exceeds 0.050
INCH.
b. Install strut (2) on base (17) and strut (18).
Torque nut (21) to 3360 to 3640 INCH-POUNDS.
(1) Aline strut (2) on base (17) and strut (18). Use
driftpin.
(2) Install bolt (20) through washer (23), strut
(18), base (17), and strut (2).
NOTE
Nut may be reused if run-on torque ex-
ceeds 50 INCH-POUNDS.
(3) Hold bolt (20). Use box wrench.
(4) Ensure nut (21) has no less than 50 INCH-
POUNDS run-on torque. Use torque wrench.
(5) Install washer (22) and nut (21) on bolt (20)
finger tight. Use ratchet and 5-inch extension.
GO TO NEXT PAGE
26
24
M04-1472-7
2
27
25
17
2
M04-1472-8
20
21
23
22
18