TM 1-1520-238-23
2-348
Change 6
2.95.
RIGHT AFT SIDE TRANSMISSION ROTOR SUPPORT STRUT ASSEMBLY
REMOVAL/INSTALLATION
2.95.5. Inspection
a. Check struts and base for damage and corro-
sion (para 2.11).
b. Check nuts and bolts for stripped threads.
None allowed.
c. Check strut bushing bores.
(1) Check for scoring, nicks, and scratches.
Scoring, nicks, and scratches are acceptable
if less than 0.020 INCH deep.
(2) Check strut support bushing bores (four
places). Maximum I.D. 0.7520 INCH.
(3) Check mast support bushing bores (two
places). Maximum I.D. 0.7510 INCH.
2.95.6. Installation
a. Install strut (2) on strut (14). Torque two nuts
(16) to 600 INCH-POUNDS.
(1) Install two bolts (15) through struts (2) and
(14).
(2) Hold two bolts (15). Install washers (17) and
nuts (16).
(3) Torque nuts (16) to 600 INCH-POUNDS. Use
torque wrench and adapter.
(4) Check for maximum gap of 0.050 INCH under
washer (17) at bolt (15) head and nut (16)
side. Replace bolt (15) if gap exceeds 0.050
INCH.
GO TO NEXT PAGE
M04-1474-5
17
16
15
2
14
