TM 1-1520-238-23
Change 5
2-360.1
2.98.
ELECTRONIC COMPARTMENT SUPPORT ASSEMBLY (HARS)
REMOVAL/INSTALLATION – continued
2.98.6. Repair
WARNING
Do not drill into hardened steel pin, twist
drill may break causing injury or damage
to support assembly.
CAUTION
Ensure alinement pin mounting hole is
not enlarged or damaged when removing
damaged alinement pin.
a. Remove defective pin (16) or (17) from sup-
port (1).
(1) Locate and mark center of alinement pin (16)
or (17) on bottom of support (1).
NOTE
For forward (tapered) pin (16) location
go to step (2).
For aft (diamond) pin (17) location go
to step (3).
(2) Drill a 0.098 INCH diameter by 0.68 INCH
deep hole through bottom of support (1) as
marked
at
forward
location
(TM 1-1500-204-23). Go to step (4).
(3) Drill a 0.098 INCH diameter by 0.26 INCH
deep hole through bottom of support (1) as
marked at aft location (TM 1-1500-204-23).
(4) Insert punch into access hole and drive de-
fective pin (11) or (12) from support (1).
(5) Remove drill filings from hole. Use vacuum
cleaner.
b. Measure pin hole, maximum diameter 0.1874
INCH.
c. Press new pin (16) or in respective hole
(TM 1-1500-204-23).
d. Touch
up
paint
on
support
(1)
(TM 55-1500-345-23).
GO TO NEXT PAGE
1
M04-3633-4
16
VIEW
ROTATED
17
M04-3633-5
0.50
0.625
