TM 1-1520-238-23
9-235
9.66.
PILOT EXT LT/INTR LT PANEL RESISTOR R1, R2, R3, R7, R8, OR R9 REPLACEMENT
(AVIM) – continued
9.66.3. Removal
a. Remove component board A2 (1) from pilot
EXT LT/INTR LT panel (2).
(1) Remove three screws (3), lockwashers (4),
and washers (5).
(2) Remove board (1) and three spacers (6).
WARNING
Soldering iron can cause severe
burns to personnel and start fires.
Observe all safety precautions when
using soldering iron. If injury occurs,
seek medical aid.
b. Remove resistor (7) from component board
A2 (1).
(1) Identify and desolder wires (8) from resistor
(7). Use soldering iron (TM 55-1500-323-24).
(2) Remove two screws (9), washers (10), and
nuts (11).
(3) Remove and discard resistor (7).
c. Remove resistor (7) from component board
A1 (11).
(1) Identify and desolder wires (8) from resistor
(7). Use soldering iron (TM 55-1500-323-24).
(2) Remove two screws (9) and washers (10).
(3) Remove and discard resistor (7).
GO TO NEXT PAGE
M04-1389-3
5
1
2
6
10
3
9
11
7
9
8
10
VIEW
ROTATED
7
7
12
4
