TM 1-1520-238-23
9-288
Change 3
9.77.
MULTICHANNEL DIMMING CONTROLLER CHASSIS DISASSEMBLY/ASSEMBLY
(AVIM) – continued
NOTE
Multichannel dimming controller harness
is an electrical assembly consisting of
two connector mounting plates, an inter-
connect printed wiring board (PWB), and
four receptacles.
Do not cut, detach, or depin wires that
connect controller harness components
to each other. All harness components
are to be removed and replaced as a
whole assembly.
d. Remove controller harness (15) from base (7)
and panel (2).
(1) Remove aft connector mounting plate (16)
from base (7).
(a) Remove two screws (17) and washers (18)
from both ends of plate (16).
(b) Remove screw (19) and washer (20)
from center of plate (16).
(c) Lift plate (16) off base (7) and remove two
spacers (21) and spacer (22).
(d) Position plate (16) on base (7) until all
other harness components are removed.
(2) Remove forward connector mounting plate (23)
from base (7).
(a) Remove six screws (24) and washers (25)
from plate (23).
(b) Ensure that plate (23) is free of base (7)
by slightly lifting plate (23) off base (7).
(c) Position plate (23) on base (7) until all
other harness components are removed.
GO TO NEXT PAGE
7
16
17
18
M04-4208-5
19
20
22
21
2
15
23
24
25
7
M04-4208-6
