TM 1-1520-238-23
9-289
9.77.
MULTICHANNEL DIMMING CONTROLLER CHASSIS DISASSEMBLY/ASSEMBLY
(AVIM) – continued
(3) Remove interconnect printed wiring board (26)
from panel (2).
(a) Remove five screws (27), nuts (28), wash-
ers (29), and spacers (30) from panel (2).
(b) Remove board (26) from panel (2).
(4) Remove receptacle (A403)J1 (31) from panel
(2).
NOTE
On receptacle (A403)J1, only the
mounting hardware on the lower left–
hand corner (looking from rear) has a
grounding terminal lug installed.
After removing mounting hardware
from receptacle (A403)J1, allow re-
ceptacle to remain inside front panel
until all other receptacles are re-
moved.
(a) Hold four screws (32). Remove nuts (33),
lockwashers (34), washers (35), and ter-
minal lug (36) from receptacle (31).
(b) Remove four screws (32) and washers
(39) from panel (2).
(c) Ensure that receptacle (31) is free of pan-
el (2) by slightly sliding receptacle (31) off
panel (2).
GO TO NEXT PAGE
M04-4208-7
29
26
2
27
30
28
M04-4208-8
2
32
37
31
35
33
34
36
