TM 1-1520-238-23
11-278
11.60.
LONGITUDINAL FEEL SPRING CARTRIDGE INSTALLATION – continued
11.60.3. Installation
a. Install feel spring cartridge (1) on magnetic
brake arm (2). Torque nut (3) 30 to 40 INCH-
POUNDS.
(1) Aline cartridge (1) with arm (2).
(2) Install bolt (4) through washers (5) (as re-
quired), bushing (6), arm (2), and cartridge
(1).
(3) Check fit of self-retaining bolt (4) (para 11.1).
(4) Install nut (3). Torque nut (3) to 30 INCH-
POUNDS. Use torque wrench.
(5) Increase torque to aline cotter pin hole, but do
not exceed 40 INCH-POUNDS.
(6) Install new cotter pin (7).
CAUTION
To prevent operational failure of feel
spring cartridge, rod end shall not be
stretched to aline rod end with bellcrank.
b. Install rod end (8) on bellcrank (9). Torque nut
(10) 30 to 40 INCH-POUNDS.
(1) Install bolt (11) through washers (12) (as re-
quired), bushing (13), bellcrank (9), and rod
end (8) to aline rod end (8) with bellcrank (9).
(a) If rod end (8) alines with bellcrank (9), go
to step b.(10).
(b) If rod end (8) does not aline with bellcrank
(9), go to step b.(2).
GO TO NEXT PAGE
M04-1710-2
1
4
5
6
2
3
7
M04-1710-3
9
8
12
11
13
10
