TM 1-1520-238-23
11-557
11.126. LONGITUDINAL F.S. 164.38 BELLCRANK REMOVAL/INSTALLATION – continued
c. Install rod (11) on bellcrank (12). Torque nut
(14) 30 to 40 INCH-POUNDS.
(1) Position rod (11) on bellcrank (12) to aline bolt
holes and bushing (16) in bellcrank (12).
NOTE
The maximum thickness for washer stack
up is 0.124 INCH for this push-pull rod
connection to bellcrank.
(2) Install bolt (17) through two washers (18),
counterbalance weight (19), bellcrank (12),
rod (11), bushing (16), and counterbalance
weight (15).
(3) Check fit of self-retaining bolt (17) (para
11.1).
(4) Install nut (14). Torque nut (14) to 30 INCH-
POUNDS. Use torque wrench.
(5) Increase torque to aline cotter pin hole, but do
not exceed 40 INCH-POUNDS.
(6) Install new cotter pin (13).
d. Inspect (QA).
e. Remove -9 rig pin (4) from pilot cyclic stick
housing (3).
f. Remove cover (5) from cyclic stick (1).
GO TO NEXT PAGE
M04-2384-12
16
15
14
13
17
12
19
18
11
4
2
M04-2384-9
1
3
5
