TM 1-1520-238-23
11-739
11.167. DIRECTIONAL F.S. 159.98 BELLCRANK AND BRACKET REMOVAL/INSTALLATION continued
e. Install rod end (17) on bellcrank (4). Torque nut
(21) 30 to 40 INCH-POUNDS.
(1) Aline rod end (17) with bellcrank (4) and hole
(19) in bracket (13).
(2) Install bolt (18) through washer (22), bushing
(23), hole (19), bellcrank (4), and rod end
(17).
(3) Install nut (21). Torque nut (21) to 30 INCH-
POUNDS. Use torque wrench.
(4) Increase torque to aline cotter pin hole, but do
not exceed 40 INCH-POUNDS.
(5) Install new cotter pin (20).
f. Install rod ends (1) and (2) on bellcranks (3)
and (4). Torque nuts (7) and (14) 30 to 40 INCH-
POUNDS.
(1) Aline rod end (2) with bellcrank (4) and hole
(12) in bracket (13).
(2) Install bolt (11) through washer (15), bushing
(16), hole (12), bellcrank (4), and rod end (2).
(3) Check fit of self-retaining bolt (11) (para 11.1).
(4) Aline rod end (1) with bellcrank (3).
(5) Install bolt (8) through washer (9), bushing
(10), bellcrank (3), and rod end (1).
(6) Install nut (7) on bolt (8).
(7) Install nut (14) on bolt (11).
(8) Torque nuts (7) and (14) to 30 INCH-
POUNDS. Use torque wrench.
(9) Increase torque to aline cotter pin hole, but do
not exceed 40 INCH-POUNDS.
(10) Install two new cotter pins (5) and (6).
GO TO NEXT PAGE
1
M04-3392-14
17
18
22
4
13
21
19
20
23
11
14
2
15
5
16
12
10
8
9
6
7
3