TM 1-1520-238-23
11-987
11.231.
STABILATOR POSITION TRANSDUCER REMOVAL/INSTALLATION – continued
f. On pilot collective stick (2), hold stabilator
switch (1) to NU (nose up) position until trail-
ing edge of stabilator (3) is full up.
g. Remove external electrical power (para 1.70).
h. On pilot aft circuit breaker panel, open STAB
circuit breaker MAN DC and MAN AC.
i. Secure bracket (8) to stabilator.
(1) Install lower screw (6) and washer (7).
j. Install clamp (9).
(1) Install screw (10) through washer (11), clamp
(9), and spacer (12).
k. Install two clamps (13) and (14).
(1) Install screw (15) through washer (16),
clamps (13) and (14), and spacer (17).
(2) Tighten screw (15).
l. Tighten bolt (4) on clamp (5).
m. Attach transducer connector P1076 (18) to re-
ceptacle J1076 (19).
n. On pilot aft circuit breaker panel, close STAB
circuit breakers MAN DC and MAN AC.
o. Perform rigging horizontal stabilator (para
11.298).
p. Inspect (QA).
q. Install access cover R545 (para 2.2).
END OF TASK
FRICTION
INCREASE
ND
NU
RESET
2
3
1
M04-2262-10
8
17
14
16
15
13
18
19
7
10
11
9
12
6
4
5
M04-2262-11
