TM 1-1520-238-23
11-982
11.230.
STABILATOR CONTROLLER ELECTRICAL CHASSIS REPAIR (AVIM) continued
11.230.6. Installation
a. Install holder (1) on plate (2) or (3).
(1) Apply adhesive film (5) on holder mounting
area of plate (2) or (3). Use adhesive film
(item 24, App F).
(2) Ensuring a visible adhesive flow is present on
both sides of holder (1), install holder (1) on
film (5).
(3) Apply a pressure of 15 to 50 psi to holder (1).
Use appropriate shot bag from electronic
equipment maintenance kit.
(4) While maintaining a pressure of 15 to 50 psi,
cure adhesive at 350 F (177 C) for 2
HOURS, then cool to 150 F (66 C) or less.
Use oven.
(5) Install four rivets (4) on plate (2) or (3)
(TM 1-1500-204-23).
b. Adjust locking screw (6).
(1) Place 0.045 0.001 INCH thickness gage in
circuit card track (7) of holder (1). Use
thickness gage.
(2) Torque screw (6) to 20 INCH-OUNCES. Use
torque wrench.
(3) Remove thickness gage from track (7).
c. Inspect (QA).
d. Install stabilator controller interconnect CCA
(para 11.229).
e. Install stabilator controller CCA (para 11.228).
END OF TASK
2
1
3
M04-4423-2
1
5
4
M04-4423-3
7
6