TM 1-1520-238-23
11-1024
11.241.
CPG DIRECTIONAL CONTROL PEDAL PIVOT SUPPORT ASSEMBLY
REMOVAL/INSTALLATION – continued
11.241.6. Installation
a. Install support (2) on crank (8). Torque nut (10)
180 to 300 INCH-POUNDS.
(1) Aline support (2) with crank (8).
(2) Install bolt (11).
(3) Check fit of self-retaining bolt (11) (para 11.1).
(4) Install nut (10). Torque nut (10) to 180 INCH-
POUNDS. Use torque wrench.
(5) Increase torque to aline cotter pin hole, but do
not exceed 300 INCH-POUNDS.
(6) Install new cotter pin (9).
b. Install rod (1) on support (2). Torque nut (4) 30
to 40 INCH-POUNDS.
(1) Aline rod (1) with support (2).
(2) Install bolt (6) through bushing (7), support
(2), and rod (1).
(3) Check fit of self-retaining bolt (6) (para 11.1).
(4) Install washer (5) and nut (4). Torque nut (4)
to 30 INCH-POUNDS. Use torque wrench.
(5) Increase torque to aline cotter pin hole, but do
not exceed 40 INCH-POUNDS.
(6) Install new cotter pin (3).
GO TO NEXT PAGE
M04-4434-5
VIEW ROTATED
10
9
2
11
8
M04-4434-6
VIEW ROTATED
2
7
6
1
3
4
5
