TM 1-1520-238-23
11-1106
11.262.
TAIL ROTOR SWASHPLATE REMOVAL/INSTALLATION – continued
CAUTION
To prevent damage to brushes, shunts,
and springs, ensure that brush block as-
sembly is not dropped, or handled rough-
ly.
NOTE
Convoluted covering on wire harness
may lose flexibility if crushed or kinked.
f. Install brush block (1) in swashplate (2).
(1) Aline two grommets (15) flat-side up, with
slots (31) in housing (12).
(2) Position brush block (1) with terminal stacks-
ups (32) outboard, and brushes (33) alined
with slip ring grooves (34).
(3) Gently lower brush block (1) into housing
(12).
(4) Slide two grommets (15) into slots (31).
(5) Tighten four captive screws (13) to secure
brush block (1) in housing (12).
(6) Position gasket (11) on housing (12) to aline
holes.
(7) Position cover (10) on gasket (11) and hous-
ing (12).
(8) Install four screws (8) through washers (9),
cover (10), and gasket (11) into housing (12).
(9) Position clamp (5) around harness (14) to
aline hole in bracket (7).
(10) Install screw (6) through clamp (5), bracket
(7), and washer (4).
(11) Install nut (3) on screw (6).
GO TO NEXT PAGE
9
11
14
15
13
2
4
3
5
6
31
1
12
32
M04-1754-8
33
34
8
10
7
15
