TM 1-1520-238-23
11-1198
11.283.
RIGGING PILOT AND CPG COLLECTIVE STICK STOP BOLTS – continued
n. Observe collective servocylinder piston (24)
travel.
o. Fully retract piston (24) by slowly pulling up
on pilot collective stick (4).
(1) Slowly pull up on stick (4) until piston (24) is
fully retracted.
(2) Stop moving stick (4). Rotate friction lock (3)
clockwise to hold stick in position.
p. Measure and record distance between valve
arm (13) and collective servocylinder stop
bolt (14).
(1) This is measurement B. Use caliper.
(2) If difference between measurements A and B
is more than 0.030 INCH, slowly lower stick
(4) until difference between measurement A
and measurement B is less than 0.030 INCH.
(3) If the difference between measurements A
and B is less than 0.030 INCH go to step q.
(4) Use friction lock (3) on pilot collective stick (4)
to hold stick in position.
q. Adjust pilot collective stick up limit stop bolt
(15) to contact stick (4).
(1) Rotate stop bolt (15) counterclockwise until it
contacts stick (4).
(2) Hold stop bolt (15). Tighten jam nut (17).
(3) Lockwire stop bolt (15) to jam nut (17) and
housing (7). Use wire (item 224, App F).
GO TO NEXT PAGE
M04-3014-17
1314
24
B
M04-3014-16
7
17
15
3
4
