TM 1-1520-238-23
11-1228
11.288. RIGGING UPPER LONGITUDINAL FLIGHT CONTROLS – continued
CAUTION
To prevent damage, be sure rigging fix-
ture is clear of mixer assembly when
moving flight controls.
t. Check that center point of alinement tool (22)
is between MIN and MAX marks on cyclic FWD
pointer (26).
(1) Slowly push pilot cyclic stick (7) forward until
it stops.
(2) Place rigging fixture (20) next to alinement
tool (22).
(3) If center point of alinement tool (22) is not
between MIN and MAX marks on FWD point-
er (26), adjust pilot and CPG cyclic stick stops
(para 11.287).
(4) If center point of alinement tool (22) is be-
tween MIN and MAX marks on FWD pointer
(26) go to next step.
u. Check that center point of alinement tool (22)
is between MIN and MAX marks on cyclic AFT
pointer (27).
(1) Slowly pull pilot cyclic stick (7) aft until it
stops.
(2) If center point of alinement tool (22) is not
between MIN and MAX marks on AFT pointer
(27), adjust pilot and CPG cyclic stick stops
(para 11.287).
(3) If center point of alinement tool (22) is be-
tween MIN and MAX marks on AFT pointer
(27), go to next step.
(4) Remove alinement tool (22) and rigging fix-
ture (20).
GO TO NEXT PAGE
MAX.
MIN.
26
22
20
7
M04-3019-11
MAX.
MIN.
27
22
7
M04-3019-12
