TM 1-1520-238-23
11-1232
11.289.
RIGGING LATERAL FLIGHT CONTROLS BETWEEN PILOT AND CPG CYCLIC
STICKS – continued
11.289.3. Rigging
a. Remove F. S. 165 rod end (1) from lateral ser-
vocylinder input linkage (2).
(1) Remove and discard cotter pin (3).
(2) Remove nut (4) from bolt (5).
(3) Remove bolt (5) and washer (6).
b. Remove lateral decoupler access door (7).
(1) Remove 15 screws (8) and washers (9).
(2) Remove door (7).
c. Enter pilot station (para 1.56). Observe all
safety precautions.
d. Slowly move pilot cyclic stick (10) to aline lat-
eral rig pin holes (11) in pilot cyclic stick sup-
port (12).
e. Install -5 rig pin (13) in rig pin holes (11) in
support (12). Use flight control rigging kit.
f. Install cyclic stick warning covers (14). Use
flight control rigging kit.
g. Install -9 rig pin (15) in rig pin holes (16) of
lateral F.S. 133 bellcrank (17) and bracket (18).
Use flight control rigging kit.
(1) If -9 rig pin (15) cannot be installed, adjust aft
end of lateral F.S. 133 push-pull rod (19) to
aline rig pin holes (16) (para 11.2).
(2) Install -9 rig pin (15).
GO TO NEXT PAGE
1
5
2
4
3
M04-3022-12
6
7
9
8
M04-3022-1
12
14
13
10
M04-3022-2
11
M04-3022-3
15
16
17
18
19
