TM 1-1520-238-23
11-1233
11.289.
RIGGING LATERAL FLIGHT CONTROLS BETWEEN PILOT AND CPG CYCLIC
STICKS – continued
h. Install -9 rig pin (20) in rig pin holes (21) of
lateral F.S. 111 bellcrank (22) and bracket (23).
Use flight control rigging kit.
(1) If -9 rig pin (20) cannot be installed, adjust
forward end of F.S. 111 push-pull rod (24) to
aline rig pin holes (21) (para 11.2).
(2) Install -9 rig pin (20).
i. Enter CPG station (para 1.56). Observe all
safety precautions.
j. Install -5 rig pin (25) into rig pin holes (26) in
CPG cyclic stick support (27). Use flight control
rigging kit.
(1) If -5 rig pin (25) cannot be installed, adjust
forward end of lateral F.S. 65 push-pull rod
(28) to aline rig pin holes (26) (para 11.2).
(2) Install -5 rig pin (25).
NOTE
Rig pins installed must be a drop-fit con-
dition in holes. (A slight drag of rig pin is
acceptable.)
k. Verify drop fit of rig pins (13), (15) (20), (25).
l. Remove -5 rig pin (25) from CPG cyclic stick
support (27).
m. Remove -9 rig pin (20) from lateral F.S. 111
bellcrank (22) and bracket (23).
GO TO NEXT PAGE
M04-3022-4
24
22
20
23
21
M04-3022-5
27
25
28
26
27
25
M04-3022-13
M04-3022-7
20
22
23
