TM 1-1520-238-23
11-1244
11.291.
RIGGING PILOT AND CPG LATERAL CYCLIC STICK STOP BOLTS – continued
r. Measure and record distance between valve
arm (8) and stop bolt (9) on lateral servocy-
linder (6).
(1) This is measurement C. Use caliper.
(2) If difference between measurements A and C
is more than 0.030 INCH, move pilot cyclic
stick (1) slowly left until difference between
measurement A and measurement C is less
than 0.030 INCH.
(3) If difference between measurements A and C
is less than 0.030 INCH go to next step.
(4) Hold stick (1) in this position.
s. Adjust pilot cyclic stick right limit stop bolt
(11) to contact stick (1).
(1) Rotate right limit stop bolt (11) counterclock-
wise until it contacts stick (1).
(2) Hold stop bolt (11). Tighten jam nut (13).
(3) Lockwire jam nut (13) to jam nut (23) and stop
bolt (24). Use wire (item 224, App F).
t. Adjust CPG cyclic stick right stop bolt (16) for
a 0.020 INCH gap between head of bolt (16)
and stick (21).
(1) Hold pilot cyclic stick against right limit stop
bolt (11).
(2) Hold 0.020 INCH thickness gage (22) against
CPG stick (21) at bolt (16) contact area.
(3) Rotate right limit stop bolt (16) counterclock-
wise until it contacts thickness gage (22).
(4) Hold stop bolt (16). Tighten jam nut (18).
(5) Lockwire jam nut (18) to jam nut (25) and stop
bolt (26). Use wire (item 224, App F).
GO TO NEXT PAGE
9
8
C
6
M04-3024-9
1
13
11
M04-3024-6
PILOT
23
24
VIEW LOOKING AFT
CPG
16
18
22
M04-3024-11
21
25
26
