TM 1-1520-238-23
11-1242
11.291.
RIGGING PILOT AND CPG LATERAL CYCLIC STICK STOP BOLTS – continued
h. Back off pilot cyclic stick (1) left limit stop bolt
(10) and right limit stop bolt (11).
(1) Remove lockwire.
(2) Loosen jam nuts (12) and (13).
(3) Turn stop bolts (10) and (11) into housing
(14).
i. Back off CPG cyclic stick stick left limit stop
bolt (15) and right limit stop bolt (16).
(1) Remove lockwire.
(2) Loosen jam nuts (17) and (18).
(3) Turn stop bolts (15) and (16) into housing
(19).
j. Observe lateral servocylinder piston (20) trav-
el.
k. Fully retract piston (20) by slowly moving pilot
cyclic stick (1) left.
(1) Slowly push left on stick (1) until piston (20) is
fully retracted.
(2) Hold stick (1) in this position.
l. Measure and record distance between valve
arm (8) and stop bolt (9) on lateral servocy-
linder (6).
(1) This is measurement B. Use caliper.
(2) If difference between measurements A and B
is more than 0.030 INCH, move cyclic stick
(1) slowly right until difference between mea-
surement A and measurement B is less than
0.030 INCH.
(3) If difference between measurements A and B
is less than 0.030 INCH go to next step.
(4) Hold stick (1) in this position.
GO TO NEXT PAGE
M04-3024-4
13
12
10
11
14
PILOT
1
CPG
VIEW LOOKING AFT
M04-3024-15
17
16
18
19
15
M04-3024-14
1
20
9
8
B
6
M04-3024-5
