TM 1-1520-238-23
11-1241
11.291. RIGGING PILOT AND CPG LATERAL CYCLIC STICK STOP BOLTS – continued
11.291.3. Rigging
a. Enter pilot station (para 1.56). Observe all
safety precautions.
b. Slowly move pilot cyclic stick (1) to aline later-
al rig pin holes (2) in cyclic stick support (3).
c. Install -5 rig pin (4) in pilot cyclic stick support
(3). Use flight control rigging kit.
NOTE
Rig pins installed must be a drop-fit con-
dition in holes. (A slight drag of rig pin is
acceptable.)
d. Verify drop-fit of rig pin (4).
e. Check that lower lever (5) on lateral servocy-
linder (6) is alined with upper edge of boss (7)
on servocylinder body.
(1) If lower lever (5) is not alined with upper edge
of boss (7) on servocylinder (6), rig lateral
controls between pilot stick and lateral servo-
cylinder (para 11.290).
(2) If lower lever (5) is alined with upper edge of
boss (7) on servocylinder (6), go to next step.
f. Measure and record distance between valve
arm (8) and stop bolt (9) on lateral servocy-
linder (6).
(1) This is measurement A. Use caliper.
g. Remove -5 rig pin (4) from pilot cyclic stick
support (3).
GO TO NEXT PAGE
1
2
3
4
M04-3024-1
PILOT
5
7
6
M04-3024-2
9
8
A
6
M04-3024-3
3
4
M04-3024-13
PILOT
