TM 1-1520-238-23
11-1243
11.291.
RIGGING PILOT AND CPG LATERAL CYCLIC STICK STOP BOLTS – continued
m. Adjust pilot cyclic stick left limit stop bolt (10)
to contact stick (1).
(1) Rotate stop bolt (10) counterclockwise until it
contacts stick (1).
(2) Hold stop bolt (10). Tighten jam nut (12).
(3) Lockwire jam nut (12) to housing (14). Use-
wire (item 224, App F).
n. Adjust CPG cyclic stick left stop bolt (15) for a
0.020 INCH gap between head of bolt (15) and
stick (21).
(1) Hold pilot cyclic stick (1) against left limit stop
bolt (10).
(2) Hold 0.020 INCH thickness gage (22) against
CPG stick (21) at bolt (15) contact area.
(3) Rotate left limit stop bolt (15) counterclock-
wise until it contact thickness gage (22).
(4) Hold stop bolt (15). Tighten jam nut (17).
(5) Lockwire jam nut (17) to housing (19). Use
wire (item 224, App F).
o. Inspect (QA).
p. Observe lateral servocylinder piston (20) trav-
el.
q. Fully extend piston (20) by slowly moving pi-
lot cyclic stick (1) right.
(1) Slowly move stick (1) right until piston (20) is
fully extended.
(2) Hold stick (1) in this position.
GO TO NEXT PAGE
14
12
10
M04-3024-10
PILOT
1
CPG
M04-3024-7
VIEW LOOKING AFT
22
15
17
15
21
21
19
M04-3024-8
1
20
