TM 1-1520-238-23
Change 8
16-63
16.13.
PYLON ACTUATOR ROD END REMOVAL/INSTALLATION - continued
b. Remove rod end (1) from actuator rod (7).
(1) Measure and record distance A between cen-
ter of rod end (1) and bottom of rod (7) before
removing rod end (1).
(2) Remove lockwire from nut (8).
(3) Hold rod (7). Loosen nut (8).
(4) Remove rod end (1), keywasher (9), and
lockwasher (10).
16.13.4. Cleaning
a. Wipe removed and attaching parts with clean
dry rag.
16.13.5. Inspection
a. Check rod end and actuator rod for stripped
threads or cracks. None allowed.
b. Check rod end and rod for corrosion (para
1.49).
c. Check pylon frame yoke for damaged or worn
bushings. If damaged or worn replace bushings
(para 16.25).
16.13.6. Installation
CAUTION
Rod end shaft must block inspection hole
in actuator rod after adjustment.
a. Install rod end (1) in rod (7).
(1) Thread nut (8) on rod end (1).
(2) Aline tab (11) on lockwasher (10) with groove
(12) on rod end (1).
(3) Install lockwasher (10) on rod end (1).
(4) Install keywasher (9) on rod end (1).
(5) Aline teeth (13) of keywasher (9) and lock-
washer (10).
GO TO NEXT PAGE
9
1
8
10
7
M04-3397-3
A
13
7
9
M04-3397-4
12
10
8
1
11
