TM 1-1520-238-23
16-64
Change 8
16.13.
PYLON ACTUATOR ROD END REMOVAL/INSTALLATION - continued
(6) Install rod end (1), nut (8), lockwasher (10),
and keywasher (9) in rod (7).
(7) Adjust rod end (1) to recorded measurement.
b. Install rod end (1) in yoke (2).
(1) Install bolt (4) through yoke (2) and rod end
(1).
(2) Install washer (6) and nut (5).
c. Perform
pylon
boresight
(TM 9-1230-476-20-1).
CAUTION
Rod end shaft must block inspection hole
in actuator rod after adjustment.
NOTE
Perform steps d. thru k. if rod end adjust-
ment is necessary.
d. Adjust rod end (1) by turning rod (7) to move
the rod end (1) up or down.
e. Slide keywasher (9) and lockwasher (10) to-
ward rod (7).
f. Aline tabs (14) of keywasher (9) with grooves
(15) of rod (7).
NOTE
Ensure tab washer and lockwasher teeth
aline.
g. Hold rod (7). Tighten nut (8).
h. Tighten rod end (1). Torque nut (5) 285 to 500
INCH-POUNDS.
(1) Hold bolt (4). Torque nut (5) to 285 INCH-
POUNDS. Use torque wrench.
GO TO NEXT PAGE
1
8
10
9
7
7
1
M04-3397-6
15
14
2
4
M04-3397-5
1
6
5
