TM 1-1520-238-T-7 11–388.2 Change 5 11–100. PILOT AND/OR CPG STAB POS INDICATORS – DO NOT INDICATE FULL NOSE UP 11–100 POS (9 2), FULL DOWN (35 2), OR OFF FLAG APPEARS (cont) 8. Attach (MT19)P1076 to J1076. Detach P473 from (A326)J6. Check for 4 VAC minimum between: P473–A15 and P473–A16, P473–A15 and P473–A17, P473–A16 and P473–A17. Is voltage present? YES Go to step 9. NO Repair open wire between: J1076–A and P473–A15, J1076–B and P473–A16, J1076–C and P473–A17. Go to paragraph 11–88. 9. Attach P473 to (A326)J6. Detach P982 from (M52)J1. Check for 4 VAC minimum between: P982–A and P982–B, P982–A and P982–C, P982–B and P982–C. Is voltage present? YES Go to step 10. NO Repair open wire between: P982–A and P472–A13, P982–B and P472–A14, P982–C and P472–A15, (A326)J15–A13 and (A326)TB1–13–A, (A326)J15–A14 and (A326)TB1–13–D, (A326)J15–A15 and (A326)TB1–13–G, (A326)TB1–13–C and (A326)J6–A15, (A326)TB1–13–F and (A326)J6–A16, (A326)TB1–13–J and (A326)J6–A17. Go to paragraph 11–88. 10. Attach P982 to (M52)J1. Detach P981 from (M51)J1. Check for 4 VAC minimum between: P981–A and P981–B, P981–A and P981–C, P981–B and P981–C. Move stabilator slightly to observe sine wave voltage. Use collective NU and ND switch. Is voltage present? YES Go to step 11. NO Repair open wire between: P981–A and P413–B2, P981–B and P413–B3, P981–C and P413–B4, (A326)J10–B2 and (A326)TB1–13–B, (A326)J10–B3 and (A326)TB1–13–E, (A326)J10–B4 and (A326)TB1–13–H. Go to paragraph 11–88. 11. Does STAB POS indicator track stabilator position? YES Replace CPG STAB POS indicator (M52) (TM 1-1520-238-23). NO Replace pilot STAB POS indicator (M51) (TM 1-1520-238-23). END OF TASK