TM 55-6930-214-10
Instructions for Use of Manual Target Control CRT Page - Continued
Table 7-10.
Range of
value
Keystroke
Comments
Command
TARGET MOTION EDIT - continued
18 MOTION
0-l
18 TAB N ENTER
N = 0 to 1. 0 turns
motion off and 1 turns
motion on. Enables
pathway travel for
target site reference
numbers l-5.
19 SPEED
0 - 40 (ground)
N = 0 to 40/200. Kilo-
19 TAB N ENTER
meters per hour in
0 - 200 ( a i r )
10-kph increments.
N = 0 to 1. 0 turns
20 TAB N ENTER
20 MOTION FOR
0-1
motion for all targets
ALL TARGETS
off and 1 turns motion
for all targets on.
N = 0 to 40. Kilometers
0 - 40
21 TAB N ENTER
21 SPEED FOR
per hour in 10-kph incre-
ALL TARGETS
ments for all targets.
NOTE
Commands 02, 06, 08, and 09 are Booleans and, when entered a
second time, provide the reciprocal command (e.g., YES or NO, ON
or OFF, etc.). Commands 14, 15, and 17 through 19 affect only
those targets referenced in their respective sections. Commands
16, 20, and 21 affect all targets referenced in their respective
sections. When commands 14, 15, and 17 through 19 are used,
there are no display values for commands 16, 20, and 21.
a. The visionics pointing/remote designator control page is in group 5 (TARGETS)
and can be accessed via the data entry keyboard by keying in 581 DISPL.
b. The instructor uses line 01 to identify a target for the pilot or CPG trainee
during independent mode training. The target reference number (line 01) is sel-
ected from the target status page (value 1 to 10). When the reference number is
entered, trainee visionics art cued to a line-of-sight between the ownship and the
designated target after the trainee has executed the necessary procedures.
c. The instructor completes data entries for lines 02 through 05 on the vision-
ics pointing/remote designator control page to select and designate targets for
attack by a remote designator (e.g., GLLD). This allows the CPG trainee to prac-
tice all the procedures associated with the selection, preparation, and launching
of a missile to be controlled by a remote designator.
7-107
Change 1
