TM 55-6930-214-10
Instructions for Use of Manual Target Control CRT Page
Table 7-10.
Range of
value
Command
Keystroke
Comments
TEE CONTROL
OFF/ON
01 TEE
01 ENTER
Must be set to OFF to
STATUS
activate/remove targets.
When set to ON, motion
and hostility edit can
be done.
02 SUSPEND
YES/NO
02 ENTER
Suspends active TEE.
TEE EVENTS
Temporarily inhibits
automatic target event
insertion. Manual tar-
get control prohibited.
TARGET ACTIVATE/REMOVE
03 TAB N ENTER
N = 1 to 10. Site
03 TARGET SITE
1 - 10
reference number corres-
REFERENCE NUMBER
ponds to reference number
on target status page.
Used to count targets
being inserted. (Refer
to commands 09, 10, and
11 below.)
N = 1 to 22 and 27 to 48.
04 TAB N ENTER
04 TARGET TYPE
1 - 22
Target type number
27 - 48
NUMBER
corresponds to type
number on target type
list and identifies
specific target type.
N = 1 to 99. Site number
05 TAB N ENTER
05 TARGET SITE
1 - 99
corresponds to target
NUMBER
site list and identifies
target site location.
YES enables radar/weapons
06 ENTER
06 HOSTILE
YES/NO
firing at ownship.
ACTIVITY
N = 5-digit malfunction
07 TAB N ENTER
07 MISS-HIT
0 or 5-digit
number from malfunction
number
list for a HIT. Defines
malfunction when this
target hits ownship.
N - 0 for no malfunction
with threat hit.
Defines hot/cold
08 ENTER
08 INFARED
HOT/COLD
Change 2
7-105