TM 1-1520-238-23
3-210
Change 4
3.57.
CPG BRAKE MASTER CYLINDERS REMOVAL/INSTALLATION – continued
3.57.6. Installation
NOTE
If master cylinder is being replaced, go to
steps a. and b. If master cylinder is not
being replaced, go to step c.
a. Install elbow (9) in cap (15).
(1) Ensure nut (16) is installed on elbow (9).
(2) Lubricate new packing (17), new retainer
(17.1), and elbow (9). Use hydraulic fluid
(item 93, App F).
(3) Install retainer (17.1) and packing (17) on el-
bow (9).
(4) Install elbow (9) in cap (15). Position elbow
(9) so outlet points forward when cap (15) is
installed.
(5) Tighten nut (16) loosely.
b. Check that distance between center of bolts
(4) and (11) is 11 1/16 to 11 7/16 INCHES, with
piston cylinder rod (20) fully extended.
(1) Insert bolts (4) and (11) and sleeve bushings
(6) and (14) through rod end (19) and cap
(15).
(2) Remove lockwire from nut (21) and key
washer (21.1).
(3) Hold rod end (19). Loosen nut (21).
(4) Adjust rod end (19) to obtain 11 1/16 to 11
7/16 INCHES between centers of bolts (4)
and (11).
(5) Hold rod end (19). Loosely install nut (21).
GO TO NEXT PAGE
M04-131-6A
16
9
17
15
18
17.1
M04-131-7A
21
4
15
11
14
19
20
21.1
6
11 1/16
to
11 7/16 IN
