TM 1-1520-238-23
Change 8
2-411
2.113.
HORIZONTAL STABILATOR REMOVAL/INSTALLATION – continued
2.113.6. Installation
a. Install stabilator (2) on helicopter. Torque two
nuts (31) to 225 INCH-POUNDS.
(1) Install two spacers (40) on bolts (32).
(2) Aline pivot lugs (37) and (39) with pivot lugs
(36) and (38).
NOTE
Hold stabilator position until pivot lug
hardware is installed.
(3) Set slots in two bearings (41) at 6 and 12
o’clock. Turn two spacers (34) to aline keys in
spacers (34) with slots in bearings (41).
(4) Lubricate two bolts (32). Use grease (item 87,
App F).
NOTE
Stabilator support must be adjusted to
allow no-load installation of shoulder
bolts.
(5) Install two bolts (32) from inside stabilator (2)
through bearings (41), spacers (34), and piv-
ot lugs (36), (37), (38), and (39).
(6) Lift stabilator (2) to aline rig pin holes (25) and
(26). Insert rig pin (24) through alined rig pin
holes (25) and (26).
(7) Install two washers (33) and nuts (31) on
bolts (32).
GO TO NEXT PAGE
31
M04-2028-9
32
34
33
36
37
40
39
38
25
26
2
24
M04-2028-15
34
41
