TM 1-1520-238-23
2-414
Change 8
2.113.
HORIZONTAL STABILATOR REMOVAL/INSTALLATION – continued
NOTE
Install attaching hardware so that bolt
head is on inboard side. Bushing may be
on bolt head or nut side, depending on
actuator adjustment.
f. Install actuator (1) on stabilator (2). Torque nut
(4) 95 to 110 INCH-POUNDS.
(1) Aline actuator clevis (43) with stabilator fitting
(44).
(2) Install bushing (7) through clevis (43) and fit-
ting (44).
(3) Install bolt (5) through washer (6) and bush-
ing (7).
(4) Install nut (4) on bolt (5).
(5) Torque nut (4) to 95 INCH-POUNDS. Use
torque wrench.
(6) Increase torque to aline cotter pin hole, but do
not exceed 110 INCH-POUNDS.
(7) Install new cotter pin (3) in nut (4).
g. Inspect (QA).
GO TO NEXT PAGE
3
4
1
43
7
44
6
5
M04-2028-7
2
