TM 1-1520-238-23
4-498
Change 1
4.150.
NO. 1 OR NO. 2 ENGINE LOAD DEMAND SPINDLE FORWARD CABLE
INSTALLATION – continued
4.150.4. Adjustment
a. Adjust No. 1 engine load demand spindle
cable (2) travel length.
(1) Aline rod end (9) to bellcrank (25) and install
bolt (33).
(2) Obtain travel length of 2.39 INCHES between
center of bolt (33) and shoulder of cable (2),
by adjusting nuts (4) and (8) at cable support
(3).
(3) Remove bolt (33).
b. Adjust No. 2 engine cable (2) travel length.
(1) Aline rod end (9) to bellcrank (25) and install
bolt (33).
(2) Obtain travel length of 4.23 INCHES between
center of bolt (33) and shoulder of cable (2),
by adjusting nuts (4) and (8) at cable support
(3).
(3) Remove bolt (33).
c. Set LDS gearbox (34) in ZERO DEGREE posi-
tion and install rigging pin (35).
(1) Remove lockwire from spindle cover cap
screws.
(2) Remove rigging pin (35) from rigging pin set.
(3) Remove cap screw (36). Install in rigging pin
stowage hole (37.1).
(4) Rotate gearbox (34) to ZERO DEGREES
position. Install rigging pin (35) in hole (37).
GO TO NEXT PAGE
NO. 2 ENGINE LDS CABLE
4.23
IN
2.39 IN
NO. 1 ENGINE LDS CABLE
33
9
2
25
8
4
25
9
33
2
8
4
3
3
M04-1188-19A
M04-1188-20A
35
36
34
34
0 DEGREES
37
37.1
