TM 1-1520-238-23
Change 1
4-495
4.150.
NO. 1 OR NO. 2 ENGINE LOAD DEMAND SPINDLE FORWARD CABLE
INSTALLATION – continued
NOTE
If installing cable that appears to have
water intrusion or seal damage, proceed
to step b to dry cable. If installing new
cable with zero flight hours or serviceable
cable, drying cable is not required; pro-
ceed to step f.
b. Remove support tube (2.1) from cable (2).
(1) Place cable (2) on clean flat surface.
(2) Remove support tube (2.1) and seal (2.2) (if
installed) from cable (2). Use wrench flats
(2.4).
c. Remove all moisture from cable.
(1) Suspend cable with sliding rod (2.3) end
downward.
(2) Cycle cable until all water droplets are gone.
(3) Heat cable to 220 5 F for 3 HOURS to
ensure all moisture is removed.
d. Clean cable sliding rod (2.3) end and support
tube (2.1).
(1) Extend cable sliding rod (2.3) to full travel.
(2) Clean cable sliding rod (2.3) and support tube
(2.1). Use clean rag.
e. Install support tube (2.1). Torque to 100 INCH-
POUNDS.
(1) Install support tube (2.1) on cable (2). Apply
sealing compound (item 166, App F) on sup-
port tube (2.1) threads. Torque to 100 INCH-
POUNDS. Use torque wrench.
(2) Install new seal (2.2) on support tube (2.1)
until seal is fully seated against support tube
(2.1).
GO TO NEXT PAGE
2.1
2.2
2.4
M04-1188-4
2
2.3
2.2
2
2.1
M04-1188-2
2.3
2.2
2
2.1
2.3
M04-1188-3
