TM 1-1520-238-23
4-644
Change 1
4.182.
NO. 1 ENGINE POWER AVAILABLE SPINDLE (PAS) RIGGING PROCEDURE continued
v. Install cable rod end (24) on bellcrank (11).
Torque nut (27) 14 to 18 INCH-POUNDS.
(1) Position rod end (24) in bellcrank (11).
(2) Install bolt (26) through bellcrank (11) and rod
end (24).
(3) Check fit of self-retaining bolt (para 11.1).
(4) Hold bolt (26). Install nut (27). Torque nut (27)
to 14 INCH-POUNDS. Use torque wrench.
(5) Increase torque to aline cotter pin hole, but do
not exceed 18 INCH-POUNDS.
(6) Install new cotter pin (25).
w. Remove rig pin (20) from gearbox (18).
x. Set power levers (3) and (7) to OFF position.
GO TO NEXT PAGE
27
M04-1207-14
26
11
24
25
M04-1207-25
18
20
3
7
M04-1207-44