TM 1-1520-238-23
Change 1
4-645
4.182.
NO. 1 ENGINE POWER AVAILABLE SPINDLE (PAS) RIGGING PROCEDURE – continued
y. At HMU spindle gearbox (32), obtain 0.010 to
0.050 INCH gap between spindle stop (33) and
spindle cam (34). Use gap setting gage.
NOTE
If 0.010 to 0.050 INCH clearance cannot
be obtained, go to step b and repeat pro-
cedures.
z. Adjust power lever (3) OFF stop screw (2).
(1) With power lever (3) in OFF position, adjust
screw (2) until it touches power lever (3).
aa. Set power lever (3) to LOCKOUT position.
NOTE
If Hamilton Standard HMU is installed,
perform step ab. If Woodward HMU is
installed, perform step ac.
ab. Verify lockout by audible click from Hamilton
Standard HMU (32).
GO TO NEXT PAGE
34
33
TO.050
.010
M04-1207-27
32
M04-1207-45
3
2
3
M04-1207-29
M04-1207-46
32
