TM 1-1520-238-23
Change 7
7-119
7.34.
DIRECTIONAL SERVOCYLINDER ROD END REPLACEMENT – continued
M04-777-1
7.34.3. Removal
NOTE
If servocylinder dust boot is installed, per-
form step a. If boot is not installed, go to
step b.
a. Slide servocylinder dust boot (1) away from
piston rod (2) to get access to lock (3) and
piston flats (4).
b. Loosen nut (5) two full turns.
(1) Remove lockwire from lock (3) and nut (5).
(2) Hold piston flats (4).
(3) Loosen nut (5). Use crowfoot.
c. Support servocylinder (6). Use barrier material
(item 32, App F).
GO TO NEXT PAGE
M04-777-2A
6
5
2
3
4
1
