TM 1-1520-238-23
9-294
9.77.
MULTICHANNEL DIMMING CONTROLLER CHASSIS DISASSEMBLY/ASSEMBLY
(AVIM) – continued
c. Install controller harness (15) on base (7) and
panel (2). Torque screws (41) to 11 INCH-
POUNDS. Torque screws (32) to 7 INCH-
POUNDS. Torque screws (27), (24), (19), and (17)
to 6.5 INCH-POUNDS.
(1) Position harness (15) on base (7) and panel
(2).
(a) Position plate (23) on base (7).
(b) Position plate (16) on base (7).
(c) Position board (26) on panel (2).
(d) Slide receptacles (A403)J1 (31),
(A403)J2 (38), (A403)J3 (39), and
(A403)J4 (40) in panel (2).
(2) Install receptacles (A403)J2 (38), (A403)J3
(39), and (A403)J4 (40) on panel (2).
(a) Install 12 screws (41) and washers (46)
through panel (2) into receptacles
(A403)J2 (38), (A403)J3 (39), and
(A403)J4 (40).
NOTE
On receptacles (A403)J2 and
(A403)J3, install grounding terminal
lug on lower right-hand corner of recep-
tacle flange.
On receptacle (A403)J4, install
grounding terminal lug on lower left–
hand corner of receptacle flange.
(b) Install three terminal lugs (45) on screws
(41).
(c) Install 12 nuts (41), lockwashers (43), and
washers (44) on screws (41).
(d) Hold nuts (41). Torque 12 screws (41) to 11
INCH-POUNDS. Use torque wrench,
screwdriver bit holder, and screwdriver bit.
GO TO NEXT PAGE
38
40
31
39
M04-4208-15
7
16
23
26
2
15
2
38
39
40
44
43
41
46
42
45
M04-4208-16
