TM 1-1520-238-23
9-356
9.98.
ANTI-COLLISION LIGHT RED FLASHTUBE LAMP REPLACEMENT – continued
c. Check wire terminals for deformation and
loose attachment (para 9.61).
d. Check for cracked or discolored lens (para
9.61).
e. Check removed and attaching parts for corro-
sion (para 1.49).
9.98.6. Installation
a. Install lamp (11) in light (6).
(1) Install three screws (21) and standoffs (22)
on plate (20).
(2) Route four terminals (10) through plate (20).
Position new lamp (11) on plate (20).
(3) Install gasket (19), lens (18), and retainer (14)
on plate (20).
(4) Install screw (17) in retainer (14).
(5) Install screw (15) through plate (16) and re-
tainer (14).
(6) Install two screws (12) through lockwashers
(13) and retainer (14).
WARNING
Do not place heater near flammable
material or allow heater to contact
skin: severe burns can result. Wear
protective equipment. If injury occurs,
seek medical aid.
b. Attach four terminals (10).
(1) Install insulating sleeving (item 98, App F) on
wires before connecting.
(2) Attach four identified terminals (10).
(3) Position insulating sleeving (item 98, App F)
on terminals (10) and shrink. Use heater.
GO TO NEXT PAGE
M04-4212-3
22
21
10
20
11
19
18
12
13
17
14
15
16
6
