TM 1-1520-238-23
9-496
9.132.
PILOT W220 OR CPG W219 MICROPHONE WIRE HARNESS
DISASSEMBLY/ASSEMBLY – continued
WARNING
Do not place heater near flammable
material or allow heater to contact
skin: severe burns can result. Wear
protective equipment. If injury occurs,
seek medical aid.
NOTE
If installing new harness cable, go to step
e. If using removed harness cable, go to
step g.
e. Install one 2.0 INCH piece (31) and two 1.0
INCH pieces (32) of heat shrink tubing over
outer nylon jacket of harness cable (2).
(1) Cut harness cable (2) to 24 INCHES for pilot
W220 or 26 INCHES for CPG W219.
(2) Cut one 2.0 INCHES piece of heat shrink tub-
ing (31). Use insulation sleeving (item 102,
App F) and slide it over outer nylon jacket of
harness cable (2).
(3) Remove 3.0 INCHES of outer nylon jacket
(27) and cut off excess stay cord.
(4) Remove 2.75 INCHES of insulation from
twisted pairs (13) and (19).
(5) Remove 2.5 INCHES of braided shield from
twisted pairs (13) and (19).
(6) Cut two 1.0 INCH pieces of heat shrink tubing
(32) and slide over twisted pairs (13) and
(19). Use insulation sleeving (item 102,
App F).
GO TO NEXT PAGE
M04-4235-17
3.0 IN
2.75 IN
2.5 IN
2.0 IN
2
31
19
13
27
1.0 IN
32
19
13
M04-4235-18
