TM 1-1520-238-23
9-511
9.135.
MASS TERMINATION CONNECTOR (MTC) (1 OR 2 INCH) REPAIR continued
9.135.6. Repair
NOTE
Failure to observe correct orientation of
sleeve on wire will cause improper solder
flow or incorrect sleeve position.
a. Install sleeve (11) on wafer terminal (17).
(1) Slide blue end of sleeve (11) back over wire
(10).
(2) Position stripped end of wire (10) on wafer
terminal (17).
(3) Hold wire (10).
(4) Slide sleeve (11) over wire (10), terminal (17)
and against wafer (6).
b. Secure wire (10) in fixture (12).
(1) Press wire (10) into wire clip (18).
(2) Close and latch wire clamp (19) to secure
wires (10).
c. Check sleeve (11) and wire (10) for proper
position.
GO TO NEXT PAGE
TOWARD
WAFER
M04-3065-29
TOWARD
WIRE
YELLOW (WITH OR
WITHOUT DOT) OR
BLUE DOT WITH DOT
SOLDER
PINK OR BLUE
M04-3065-7
11
6
17
10
10
19
12
11
M04-3065-30
18
M04-3065-31
WIRES MUST END
IN THIS AREA
INSULATION
MUST END IN
THIS AREA
0.080 IN
MINIMUM OVERLAP
CUPPED AREA OF
TERMINAL (0.125 INCH)