TM 1-1520-238-23
9-512
9.135.
MASS TERMINATION CONNECTOR (MTC) (1 OR 2 INCH) REPAIR – continued
d. Heat sleeve (11). Use heating tool, nitrogen
(item 128, App F) (if on helicopter), and foil
shield.
(1) Direct hot air at sleeve (11).
(2) Hold heat gun (20) 0.125 to 0.250 INCH from
sleeve (11). Use solder (item 189, App F).
(3) Heat sleeve (11) until solder (21) melts, flows,
and wets wire (10).
e. Check for proper heating of sleeve (11) and
proper position of wires (10) on wafer termi-
nals (17).
f. Remove static ground bus (9), if installed.
g. Remove wafer (6) from fixture (12).
(1) Unlatch clamp (19).
(2) Carefully remove wire (10) from clip (18).
(3) Remove wafer (6) with wire (10) from fixture
(12).
h. Check
continuity.
Use
multimeter
(TM 55-1500-323-24).
GO TO NEXT PAGE
18
10
6
17
12
20
9
21
11
10
M04-3065-32
19
