TM 1-1520-238-23
9-521
9.136.
MASS TERMINATION CONNECTOR (MTC) WITH SHIELD BUS (1 OR 2 INCH) REPAIR – continued
9.136.4. Cleaning
a. Wipe connector and wires with a clean rag.
9.136.5. Inspection
a. Check removed and attaching parts for dam-
age (para 9.126).
b. Check wires and terminals for wear, cracks,
cuts, broken strands and proper strip sizes
(para 9.126).
c. Check removed and attaching parts for corro-
sion (para 1.49).
9.136.6. Repair
a. Install bus sleeve (14) over wire (12). Slide
sleeve (14) back at least 3.0 INCHES to avoid
interface with wafer sleeve (12) installation.
NOTE
Failure to observe correct orientation of
sleeve on wire will result in incorrect
sleeve position or improper solder flow.
b. Install wafer sleeve (13) on wafer terminal (23).
Install wire clip module (24) if not installed.
(1) Slide pink or blue end of sleeve (13) over wire
(12).
(2) Position stripped end of wire (12) on terminal
(23).
(3) Hold wire (12) and slide sleeve (13) over wire
(12) and terminal (23) against wafer (6).
GO TO NEXT PAGE
TOWARD
WAFER
M04-3066-35
TOWARD
WIRE
YELLOW (WITH OR
WITHOUT DOT) OR
BLUE DOT WITH DOT
SOLDER
PINK OR BLUE
M04-3066-36
12
23
6
14
24
13
