TM 1-1520-238-23
9-517
9.136.
MASS TERMINATION CONNECTOR (MTC) WITH SHIELD BUS (1 OR 2 INCH) REPAIR – continued
9.136.3. Removal
a. Detach connector (1) from connector (2).
(1) Loosen two captive jackscrews (3).
b. Remove two cable clamps (4) from connector
(1).
(1) Loosen two captive screws (5).
c. Remove wafer (6) with shield bus (7) from
connector (1).
(1) Insert wafer removal tool (8) into rear of con-
nector (1) and on top of wafer (6) and shield
bus (7). Use Raychem repair kit.
(2) Push tool (8) until tool locks in place.
(3) Pull tool (8) and wafer (6) with bus (7) out of
connector (1).
(4) Pull wafer (9) with bus (10) out of connector
(1).
GO TO NEXT PAGE
2
M04-3066-1
3
1
5
4
1
4
5
M04-3066-2
1
8
8
M04-3066-3
1
7
M04-3066-4
6
1
7
9
10
