TM 1-1520-238-23
9-522
9.136.
MASS TERMINATION CONNECTOR (MTC) WITH SHIELD BUS (1 OR 2 INCH) REPAIR – continued
c. Secure wire (12) in fixture (16).
(1) Press wire (12) into wire clip (25).
(2) Close and latch wire clamp (26) to secure
wires (12).
d. Check sleeve (13) and wire (12) for proper
position.
e. Isolate sleeve (13) to be heated, using mov-
able heat shields (22).
f. Heat sleeve (13). Use heat gun (27) and nitrogen
(item 128, App F) (if on helicopter).
(1) Hold heat gun (27) 0.125 to 0.250 INCH from
sleeve (13).
(2) Direct hot air at sleeve (13) until solder (28)
melts, flows, and wets wire (12).
g. Check for proper heating of wafer sleeve (13)
and proper wire position on wafer terminal
(23).
h. Remove wafer (6) from fixture (16).
(1) Unlatch clamp (26) and remove wire (12)
from clip (25).
(2) Remove wafer (6) with wire (12) from fixture
(16).
i. Remove wire clip module (24).
GO TO NEXT PAGE
12
26
25
16
M04-3066-37
25
12
26
6
22
27
28
M04-3066-39
13
23
16
24
M04-3066-38
WIRES MUST END
IN THIS AREA
INSULATION
MUST END IN
THIS AREA
0.080 IN
MINIMUM OVERLAP
CUPPED AREA OF
TERMINAL (0.125 IN)
