TM 1-1520-238-23
11-1237
11.290.
RIGGING LATERAL FLIGHT CONTROLS BETWEEN PILOT CYCLIC STICK AND LATERAL
SERVOCYLINDER – continued
11.290.3. Rigging
a. Remove F.S. 165 rod end (1) from lateral ser-
vocylinder input linkage (2).
(1) Remove and discard cotter pin (3).
(2) Remove nut (4).
(3) Remove bolt (5) and washer (6).
b. Enter pilot station (para 1.56). Observe all
safety precautions.
c. Slowly move pilot cyclic stick (7) to aline later-
al rig pin holes (8) in cyclic stick support (9).
d. Install -5 rig pin (10) in holes (8). Use flight
control rigging kit.
e. Install cyclic stick warning covers (11). Use
flight control rigging kit.
f. Apply external hydraulic power to aircraft
(para 1.72).
g. Install -9 rig pin (12) in midstroke rig pin holes
(13) on lateral F.S. 165 bellcrank (14). Use flight
control rigging kit.
(1) If -9 rig pin (12) cannot be installed, adjust
upper end of F.S. 159 push-pull rod (15) to
aline rig pin holes (13) (para 11.2).
(2) Install -9 rig pin (12).
NOTE
Rig pins installed must be a drop-fit con-
dition in holes. (A slight drag of rig pin is
acceptable.)
h. Verify drop-fit of rig pins (10) and (12).
GO TO NEXT PAGE
5
6
1
3
4
2
M04-3023-8
9
M04-3023-1
11
7
7
8
10
15
14
13
12
M04-3023-2
10
12
M04-3023-10
