TM 1-1520-238-23
11-1238
11.290.
RIGGING LATERAL FLIGHT CONTROLS BETWEEN PILOT CYCLIC STICK AND LATERAL
SERVOCYLINDER – continued
i. Slowly move lateral servocylinder input link-
age (2) to aline lower lever (16) with upper
edge of boss (17) on servocylinder body (18).
j. Check that holes in input linkage (2) aline with
lateral F.S. 165 push-pull rod end (1).
(1) If holes in input linkage (2) do not aline with
rod end (1), adjust rod end of F.S. 165 push-
pull rod (19) (para 11.2).
(2) If holes in input linkage (2) aline with rod end
(1), go to next step.
k. Install rod end (1) on input linkage (2). Torque
nut (4) 30 to 40 INCH-POUNDS.
(1) Install bolt (5) through washer (6), input link-
age (2), and rod end (1).
(2) Check fit of self-retaining bolt (5) (para 11.1).
(3) Install nut (4) on bolt (5).
(4) Torque nut (4) to 30 INCH-POUNDS. Use
torque wrench.
(5) Increase torque to aline cotter pin hole, but do
not exceed 40 INCH-POUNDS.
(6) Install new cotter pin (3).
GO TO NEXT PAGE
M04-3023-3
2
18
16
17
VIEW ROTATED
1
2
19
M04-3023-4
1
3
4
2
M04-3023-9
5
6
